DeLonghi EC702 Cleaning, Descaling and Troubleshooting Guide

DeLonghi EC702 Cleaning, Descaling and Troubleshooting Guide

The DeLonghi EC702 is a simple machine, and most of its problems come from three places: a blocked filter holder, a dirty boiler outlet, or scale inside the boiler. This DeLonghi EC702 guide covers the full care routine from De’Longhi’s own instruction manual for the EC701 and EC702, plus a troubleshooting table for the faults owners run into most.

Everything below follows the manufacturer’s manual. Where the manual tells you to stop and go to a service center, we say so.

DeLonghi EC702 maintenance schedule

Task How often Tools
Purge and wash the cappuccino frother After every milk drink Warm water, a pin
Wipe the body, wash the drip tray and tank Regularly Soft damp cloth
Take apart and clean the filter holder About every 200 coffees Brush, a pin
Remove and clean the boiler outlet About every 200 coffees Screwdriver, brush, a pin
Descale About every 200 coffees Descaler, a container
DeLonghi EC702 care schedule: purge the frother after every milk drink, wash the drip tray and tank regularly, clean the filter holder and boiler outlet and descale every 200 coffees

At two espressos a day, 200 coffees is a little over three months. De’Longhi notes that skipping the filter holder and boiler outlet cleaning invalidates the warranty, and that scale damage is covered only if you descale regularly.

Before you start

  • Turn the machine off, unplug it and let it cool before you clean the outside or remove any part.
  • Never immerse the EC702 in water. It is an electrical appliance.
  • Don’t put the filter holder in the dishwasher.
  • Don’t use solvents or abrasive cleaners. A soft, damp cloth is enough for the body.

How to clean the EC702 cappuccino frother

Milk left in the steam tube dries quickly and blocks the frother, so clean it every time you steam milk.

  1. Open the steam knob for a few seconds to push any remaining milk out of the steam tube.
  2. Hold the steam tube firmly with one hand. With the other, unscrew the frother by turning it clockwise and pulling it down.
  3. Pull the nozzle down and off the steam tube.
  4. Wash the frother and the nozzle thoroughly in warm water.
  5. Check that the two small holes in the frother are open. If they are blocked, clear them with a pin.
  6. Push the nozzle back onto the steam tube and turn it firmly toward the top of the tube.
  7. Refit the frother by inserting it and turning it counter-clockwise.

How to clean the DeLonghi EC702 filter holder

The EC702 uses a dual-function filter holder that takes ground coffee or E.S.E. pods. Coffee oils and fine grounds collect inside it, so De’Longhi asks for a full strip-down about every 200 coffees.

  1. Take the filter out of the filter holder and clean the inside of the holder.
  2. Unscrew the cap in the direction of the arrow marked on it.
  3. Push the filter out of its container from the cap end.
  4. Remove the gasket.
  5. Rinse every part. Scrub the metal filter in hot water with a brush.
  6. Hold the metal filter up to the light. If any holes are blocked, open them with a pin.
  7. Put the filter and the plastic disk back on the gasket, with the pin on the plastic disk seated in the hole in the gasket.
  8. Fit the assembly into the steel filter container, with the pin in the hole in the support.
  9. Screw the cap back on.

How to clean the EC702 boiler outlet

The boiler outlet is the perforated plate the water comes through, directly above the filter holder. When its holes clog, espresso comes out slowly or not at all.

  1. Make sure the machine is cold and unplugged.
  2. Use a screwdriver to remove the screw that holds the boiler outlet in place.
  3. Wipe the boiler surface with a damp cloth.
  4. Wash the boiler outlet in hot water with a brush. Clear any blocked holes with a pin.
  5. Rinse it under running water, rubbing as you go.
  6. Refit the boiler outlet and check that the gasket is seated correctly before you tighten the screw.

How to descale the DeLonghi EC702

De’Longhi’s manual says to descale about every 200 coffees and to use De’Longhi’s own descaler: the bottle supplied with the machine first, then descaling solution from an authorized service center. The manual doesn’t approve vinegar or other substitutes, so we don’t suggest them.

  1. Fill the water tank with 34 oz (1 liter) of water.
  2. Pour in the descaler. The bottle supplied with the machine holds 250 ml.
  3. Press the ON/OFF button and wait for the OK light.
  4. Leave the filter holder off and put a container under the boiler outlet.
  5. Press the coffee button and run about half of the tank through. Every so often, open the steam knob to let a little solution out through the steam tube. Press the coffee button again to stop.
  6. Let the solution work for about 15 minutes.
  7. Run the rest of the tank through.
  8. Rinse the tank well, fill it with clean water and run the whole tank through the machine.
  9. Fill the tank with clean water once more and run it through again.
How to descale the DeLonghi EC702 in nine steps, from filling the tank with water and descaler to two rinses with clean water

Don’t shorten the two rinses. If espresso tastes acidic after descaling, the manual’s answer is that the machine wasn’t rinsed enough: run more clean water through it.

DeLonghi EC702 troubleshooting

Problem Likely cause What to do
No espresso comes out The tank is empty Fill the tank
No espresso comes out The holes in the filter holder spouts are blocked Clean the spout holes
No espresso comes out The boiler outlet is blocked Clean the boiler outlet as described above
Espresso drips from the edge of the filter holder The filter holder isn’t locked in Reattach it and turn it as far as it goes
Espresso drips from the edge of the filter holder The boiler gasket has lost its elasticity Have the gasket replaced at a service center
Espresso drips from the edge of the filter holder The holes in the filter holder are blocked Clean the holes
Espresso is cold The OK light wasn’t on when you pressed the coffee button Wait for the OK light
Espresso is cold The machine or the cups weren’t preheated Preheat the machine and rinse the cups with hot water
The pump is very loud The tank is empty Refill the tank
Crema is pale and the shot runs too fast Coffee is tamped too lightly, there’s too little of it, or the grind is too coarse Tamp more firmly, add coffee, use an espresso grind
Crema is dark and the shot runs too slowly Coffee is tamped too hard, there’s too much of it, or the grind is too fine Tamp less firmly, use less coffee, use an espresso grind
Crema is dark and the shot runs too slowly The boiler outlet is blocked Clean the boiler outlet
Espresso tastes acidic The machine wasn’t rinsed enough after descaling Run clean water through as in the descaling steps
Milk won’t froth The milk isn’t cold enough Use milk straight from the refrigerator. De’Longhi recommends skim milk
Milk won’t froth The frother is dirty Clean the holes in the cappuccino frother

How to get better espresso from the EC702

Many “faults” are really setup. These are the settings from the manual.

  • Preheat for 15 minutes. Switch the machine on with the filter holder attached and the steam knob closed. For a faster start, attach the empty filter holder, wait for the OK light, run hot water into your cup until the light goes out, then empty the cup.
  • Dose by the scoop. One level measure, about 7 grams, for a single. Two loosely filled measures, about 6 grams each, for a double.
  • Tamp lightly and evenly. Too hard gives a slow shot with dark crema. Too light gives a fast shot with pale crema. DeLonghi’s own 50 mm stainless steel coffee tamper is listed as compatible with the EC702.
  • Warm the cups. Rinse them with hot water or leave them on the cup tray for 15 to 20 minutes.
  • Use E.S.E. pods for a no-mess shot. Fit the small filter, center the pod and lock the holder all the way. Lavazza Gran Espresso E.S.E. pods work with the EC702’s pod filter.
  • Steam milk cold. Use about 3.5 oz (100 g) of refrigerator-cold milk per cappuccino in a container two to three times that size, and stop at about 140°F (60°C).

When to stop and get the EC702 serviced

The manual is clear about what owners shouldn’t repair themselves.

  • A worn boiler gasket. If espresso still leaks around the filter holder after you have cleaned everything and locked the holder fully, the gasket needs replacing at a service center.
  • A damaged power cord. It can’t be replaced without special tools.
  • Any fault after the machine has been dropped or damaged. Switch it off and don’t open it.

Our own technicians service the machines we sell. See Warranty & Service for how repairs work.

DeLonghi EC702 FAQ

How often should I descale the DeLonghi EC702?

About every 200 coffees, according to De’Longhi’s manual. That is roughly every three months at two cups a day.

Can I use vinegar to descale the EC702?

De’Longhi’s manual says to use only its own descaler, so vinegar isn’t an approved method. Keep in mind that scale damage is covered by the warranty only when the machine has been descaled as the manual describes.

Why is my DeLonghi EC702 leaking around the filter holder?

Check three things in order: the holder is turned as far as it goes, the holes in the holder are clear, and the boiler gasket is still springy. A hardened gasket is a service-center job.

Why is there no water coming out of my EC702?

Check the tank first, then the filter holder spouts, then the boiler outlet. A clogged boiler outlet is the usual reason on a machine that hasn’t been cleaned for a long time.

Is the DeLonghi EC702 still worth buying?

It remains a straightforward 15-bar pump machine that takes both ground coffee and pods. Check the DeLonghi Esclusivo EC702 page for current availability. If it is out of stock, the DeLonghi Dedica Duo is a compact alternative in the same price range.

Sources

  • De’Longhi, instruction manual for the EC-701 and EC-702 espresso and cappuccino maker: cleaning and maintenance, descaling and troubleshooting sections.