The Profitec Pro 800 is for home baristas who enjoy the hands-on ritual of a lever machine but still want precise, modern temperature control. A spring-loaded piston drives each extraction, while a PID holds the brew temperature you set.
Highlights
- Spring lever group. As the lever rises, pressure builds and then eases off, so each shot follows a declining profile that you guide by hand.
- Low-pressure pre-infusion. Lowering the lever lets boiler pressure, roughly 1 to 1.5 bar, fill the group and wet the puck before the spring takes over.
- PID out of sight. The controller is mounted behind the drip tray, keeping the front of the machine clean and traditional.
- Large copper boiler. The insulated 118 fl oz boiler supplies both the group and the steam wand and is built for rapid steaming.
- Quiet operation. The pump runs only to refill the boiler from the reservoir, and on a water line it stays off because line pressure does the filling.
- Lever-operated steam and hot water. Steam and hot water open with levers, and an optional ECO mode turns the machine off after a programmed idle time.
Good to know
The machine comes with three portafilters (single spout, double spout and bottomless) plus single, double and triple baskets. Fill the removable 101.4 fl oz reservoir from the top or connect a water line and drain. At nearly 29 inches tall and about 78 lb, it needs a solid counter and generous clearance above.






















































Reviews
There are no reviews yet.